AERO SHIELD DIAMOND VELOCITY- Wheel Ceramic Coating
AERO SHIELD VELOCITY is the most durable
ceramic coating for wheels on the market today.
This 10H ceramic coating uses the highest
quality raw German ingredients blended with a fortified
chemical structure that blocks most
abusive contaminants found in extreme
conditions. With the power to withstand
pH ranges from less than 3 to over 12,
VELOCITY will protect your wheel and
caliper finishes from acids, salts, cleaners
and most paint strippers.
AERO SHIELD VELOCITY uses cutting edge
Nano-Hexagonal Matrix Technology to apply, in
conjunction with elevated levels of SiO2
and Titanium. AERO SHIELD VELOCITY will
give you a lifetime of rich, deep gloss while protecting
your wheels and calipers from UV fade, scratches, and
environmental damages for years.
Function: To add a 1OH ceramic protective coating
to wheels, calipers, and other highly-exposed exterior areas.
To Apply: Wash vehicle using AERO SUDS; dry thoroughly.
For a rough finish due to fallout, prepare the surface of the vehicle using AERO GLIDE to smooth and remove surface contaminants.
Wipe clean with AERO SHIELD EJECT pre-treatment to remove surface oils.
Apply 7 to 10 drops on an applicator. Systematically apply until the entire area is covered with the coating.
Wait for sweat/ flash to occur (30 sec to 3 min) wipe to level with a clean microfiber towel and buff to finish.
Repeat steps until all desired areas are covered. For additional protection, up to 3 coats may be applied, wait 1 hour between coats.
AERO SHIELD VELOCITY is fully cured in 7 days. For maintenance and increased hydrophobic properties apply AERO SHIELD HYDRO.
To extend the life of your coatings, clean regularly with water pressure and mild pH-balanced soap.
Never use acid-based or high pH degreasers.